2008 Z06

[Tony @ MPH]

We have a 2008 Z06 and 2007 Z06 showing a couple of PIDs that seem incorrect. The most obvious is throttle position which will not exceed 88%.

Is this a known issue and is there a workaround? I'll have to get back into my scanner to double check the other PID/PIDs, but I think injector duty cycle was another one that seemed incorrect.

Tony

[scdyne]

Both issues have been addressed in previous posts. I'm sorry I don't remember which ones but they were E67 questions over the last few weeks.

From memory:
Try another PID for throttle position. I'm using GM.ACCEP now and it shows 100% at WOT now instead of only 18%-85%. I think it all is related to electronic throttle control If my memory servers correctly.

[Tony @ MPH]

Thanks, I'll take a look around.