PDA

View Full Version : Voltage discrepency on V2 with AD input


Jason S.
February 10th, 2008, 11:53 AM
I did some reading and near as I can tell, you can't run the Flashscan control panel with V2 if you have updated to 2.5 firmware and calibrate the v2? The problem I am having is that the voltage measured at the V2 is off by about .17 volts, against what is displayed as the voltage in the scan tool. So it would appear that I need to recalibrate the V2, only It doesn't appear that I can with the new firmware. Any input here would be great!

Thanks
mr.prick
February 10th, 2008, 01:27 PM
are you going by word of mouth or
have you tried to calibrate it to no avail?
Jason S.
February 10th, 2008, 02:25 PM
are you going by word of mouth or
have you tried to calibrate it to no avail?

My Icon is greyed out...so I can't try it.
ntae
February 10th, 2008, 03:41 PM
go in to the V2 cable & set the voltage off set up there
Jason S.
February 10th, 2008, 04:47 PM
go in to the V2 cable & set the voltage off set up there

Can you be a little more specific.... I don't know what you mean.
ntae
February 10th, 2008, 05:35 PM
in your v2 cable there is self test / then there is a cal screen for your 0 to 5 volts in
mr.prick
February 11th, 2008, 12:59 PM
are you connected to the vehicle with the key on?
you can not be monitoring or recording to access V2 control.
Chevy366
February 12th, 2008, 05:32 AM
When are we going to get digital input , LC-1 digital out to V2 ?