View Full Version : B5908 to AFR, not EQ
Lextech
February 23rd, 2008, 01:12 AM
Is there a way to change table B5908 to display in AFR instead of EQ? I can't seem to figure out how to do it.:nixweiss:
Jeff
mr.prick
February 23rd, 2008, 04:48 AM
edit>properties>display tab.
Lextech
February 23rd, 2008, 06:09 AM
That is the strange thing about it. That is the first place I went. When I go to Edit>Properties>Display Tab, it says it should be displaying AFR, but it isn't---It is in EQ.
cmitchell17
February 23rd, 2008, 07:02 AM
Mine does the same thing, no matter what you put in the properties it is always in EQ.
So It is always hard to figure out but i always right down what EQ is in afr on a piece of paper, but I dont know how accurate that is.
It would be a lot eaiser if you could put it into AFR.
mr.prick
February 23rd, 2008, 07:15 AM
in the configure display units area there is no other options for that table.
it`s one of those things you will have to work around.
Lextech
February 23rd, 2008, 08:48 AM
Ya, that is kind of what I figured. Not really the answer I wanted though. I guess I will also make a cheat sheet.
Jeff
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.