Hyper99
February 26th, 2008, 08:08 PM
In the Fuel/O2/o2 Switch point table you define the X axis of the table as CL MODE with counts of 0 thru 64 - in 8(??) increments. The Y axis table is millivolts.There are a couple of other tables that reference the CL MODE also in the software. The descriptions of what CL MODE actually is missing- I believe that it is a counting factor, but what factors control it and if it is a defined factor in the PCM, is there a PID to access this?
I cannot find a PID or correlation between the MAF frequency or a MAP (kpa) function that tells me what CL mode I am in at any specific time. What are the factors that drive the CL MODE and how are we to access this. I want to make decisions about changing the bias table voltages based on MAP and/or MAF events but the CL MODE value does not really tell me anything since it does not relate to another known.
Please advise if another post discusses this, the search did not turn up any good info.:D
I cannot find a PID or correlation between the MAF frequency or a MAP (kpa) function that tells me what CL mode I am in at any specific time. What are the factors that drive the CL MODE and how are we to access this. I want to make decisions about changing the bias table voltages based on MAP and/or MAF events but the CL MODE value does not really tell me anything since it does not relate to another known.
Please advise if another post discusses this, the search did not turn up any good info.:D