RAFIG/RAFPN when running with MAF sensor????

[hquick]

Hi all,
I have a question.
I'm now back to running a MAF and 1 bar sensor.
My question is...do I still need to apply the RAFIG/RAFPN process?
Does it still work the same if I log and copy/paste as per the RAFIG/RAFPN process described in the appropriate threads relating to SD tunes?

Thanks

[hquick]

Well...after applying the RAFIG/RAFPN process to my truck....it wouldn't idle well at all.
On a cold start....not too bad but on a warm restart...it would stall and not run unless I pumped the accelerator a few times. Once running it was fine.
Went back to my original settings until I have time to investigate this further.