I need a new RS232 for my Flashscan V2...

[Goldfinger911]

I didnt see one on the spare parts page. Can I still order one?

By chance do you guys have the pinout diagram so I can just make one? Cat4 cable, RJ25 plug on one end with a 9 pin serial on the other end right?

Thanks.

Jason Maynard
Seattle, WA
USA

[Ira]

I don't remember the name of the file, but in the downloads area is a file containing the pinouts of all the cables.

Ira

[Goldfinger911]

I only see one post in the downloads section of the Forum. The download section of the website has this

http://download2.efilive.com/Tutorials/PDF/Bench%20Harness%20Tutorial.pdf

But that is for PCM's. Is there somewhere else?


Thanks Ira for the fast reply.

[Ira]

My bad, the one I was thinking of doesn't have the serial cable pinouts. I have them in stock or I can take a meter and pin one out for you.

Ira

[Goldfinger911]

If you could pin one out for me that would be awesome. I am thinking about custom wiring a DB9 plug/panel in the center console of my car that runs to my LC-1 then I just put my V2 in it's cradle, plug in the little patch cable and voila, I am reading O2 via serial. :)

[Ira]

It looks like this:

DB9 RJ45
2 6
3 5
5 2


If you're about to plug the RJ 45 into your mouth and the tab is down, pin 1 is to your left.

Ira

[Goldfinger911]

But... the RS232 plug isnt an RJ45... I think it is an RJ25.
Pins the same I assume? So only 3 of the 9 wires/pins on the DB9 are used?

[Ira]

You're right, it's only 6 pins and only 3 of them are used.

Ira