PDA

View Full Version : ETC Predicted Airflow



dbaxter_ss
July 25th, 2005, 12:27 PM
I have a quick question. I have a 2k1 SS and 2k4 GTO both having cable TB.

I was gong through trying to redo my tune ( something fun to do :D ).

I ran across this and figured I would create a quick pid and map to match and then noticed that what I am logging is way different the whats in the tune.
Since I dont have ETC, do I just ignore this table?

If you would like to create this pid :D

*CLC-00-993
cylair 0.0 4095.9 .0 "{CALC.CYLAIR} * 1000"


CALC.MGCYLAIR F60F CLC-00-993 "cylair" Air "Millgrams Air mass per cylinder"

http://www.purplegto.com/images/CALC.MGCYLAIR%20Grams_cyl.map

http://www.purplegto.com/images/tune-milligramspercylinder.PNG

logged

http://www.purplegto.com/images/milligramspercylinder.PNG

dbaxter_ss
July 25th, 2005, 12:31 PM
Added the GTOs logs and with the SC the logged values are even higher.

Should this table be updated to match or exceed these values?
http://www.purplegto.com/images/milligramspercylinder-gto.PNG

BowlingSS
July 26th, 2005, 02:44 AM
I have never used this table before. Hope someone else has.

Bill

hpcubed
August 5th, 2005, 01:12 PM
You could adjust the table so that you do not exceed the limit or turn the code off.

QUICKSILVER2002
August 6th, 2005, 07:17 AM
It is just a sanity check table. The car goes into a limp mode if the that code gets set (been there done that).

There is some weird dependency though with another DTC (like maf high freqency). My code never set until I enabled the other DTC.

It should work on all cars (ETC or not), but I am not sure. I thought FI f-bodies set this code also.

You can pretty much set those values as high as you want and it will not make the car run any different.

GMPX
August 6th, 2005, 02:45 PM
Try fitting a decent cam to an ETC vehicle without touching this and you will be in reduced power mode before you know it.

As the other poster said, it's a sanity check table, bump the values way up to stop reduced power mode.

Cheers,
Ross

GMPX
August 6th, 2005, 02:46 PM
http://www.purplegto.com/images/milligramspercylinder.PNG

Did you enter those row/column values manually?.

Cheers,
Ross