PDA

View Full Version : 60 lb Mototron injector setup



johnv
March 31st, 2008, 01:19 PM
Anyone help me out with injector table setup for 60 lb motoron injectors on a VZ 6ltr ute.

IFR table runs out of range for my calculated injector slope:angel_innocent:

JezzaB
March 31st, 2008, 06:35 PM
Whats the flow rate of the inj @ 43.5 psi?
Are you running 58psi fuel pressure?
Do you have a manifold vacuum referenced fuel reg and is the vac hose hooked up?

Ive got 63lb Semiens Dekkas on a VU SS Ute and they dont run off the scale.

Cheers,
Jez

johnv
March 31st, 2008, 11:19 PM
I have them in my VXII as well, no problem.

But the 6 ltr cal has a max setting of 7.9999 gms/sec :shock:
and the ls1 cal has an upper limit of 511.9922 gms/sec:)

Base fuel pressure = 58 psi, not boost referenced.
60 lb @ 43.5 psi

Going by my ls1 setup the IFRs start at 8.7266 through to 9.5625 gms/sec:help2:

johnv
April 1st, 2008, 01:53 PM
ok spotted wait4me s post on injector size fix, may have to give this a go.

Anyone know the std injector size for the VZ 6.0 ltr L76 ?