Filters not working?????

[Dopey]

Hi All,
Im trying to get my VE table dialed in and I was getting spikes here and there.... When I looked over the logs, I found ou my filters arent working...... I cant figure it out... If I exclude KR >0 then it works, but not in combo.....

If I play around with the filters enough, no matter what I do it filters everything out.... (even if I say exclude data with RPM > 6500)

Anyone else having issues?

[5.7ute]

Check how your filters are being applied with the and/or function. If you have these wrong you will have issues.

[Dopey]

checked everything 10 times... i even took a snapshot of someone elses and applied it to mine... didnt work...

[5.7ute]

Can you post a screenshot of your filter table?

[joecar]

Also check if your filter control is Include or Exclude.

[azzhauler]

I noticed a similar problem where if I selected 1 pid in the filter and used 'exclude' it worked fine, but with more than 2 pid it would not filter anything. Inverting the comparisions and selecting 'include' gets the same theoretical data set, but actually filters correctly. I never played with it long enough on 'exclude' to make it eventually block everything.