hquick
April 27th, 2008, 12:52 AM
As I've been having lean tip in issues and no 'transient fuelling' inclusion in the software in sight (Hint..hint...Ross/Paul :wave: ).
I decided to hook the maf back up, install the one bar MAP and turn the O2's back on.
I had the VE's pretty wel dialled in and also had the MAF dialled in.
As soon as it goes into closed loop the PLX guage shows lean.
Problem is...the STFT's and LTFT's are showing the PCM pulling fuel even though the wide band is showing lean???
Anyone know anything about why I would be seeing this????
Thanks
P.S. this tune shows PE enable at 35% TPS whereas it was set at 50% for the attached log.
I decided to hook the maf back up, install the one bar MAP and turn the O2's back on.
I had the VE's pretty wel dialled in and also had the MAF dialled in.
As soon as it goes into closed loop the PLX guage shows lean.
Problem is...the STFT's and LTFT's are showing the PCM pulling fuel even though the wide band is showing lean???
Anyone know anything about why I would be seeing this????
Thanks
P.S. this tune shows PE enable at 35% TPS whereas it was set at 50% for the attached log.