WB output and 24 channels for V2

[02Z06]

Do the External PID,s for the WB figure into the channel count? I am logging 24 channels but when I add the WB it will be 28 if they count. The PID descriptions in Hapi show 2 channels each for the WB outputs. The same PIDs in the scan tool show 0. Does anybody know which is right? This is with an E38 ECM. Thanks, Jim

[ChipsByAl]

This is per one of Blacky's posts:

The limits for Black Box Logging are as follows:
VPW style controllers: 24 channels (4x6).
CAN style controllers: 42 channels (6x7).

External PIDS are not gathered from the data stream, I don't see how they would matter.

[joecar]

External pids are not gotten from the PCM (they are not included in data frames returned by the PCM)... so they are "bonus".

[02Z06]

External pids are not gotten from the PCM (they are not included in data frames returned by the PCM)... so they are "bonus".
Thanks Joe + Al for the info on the channel count. One other question, I hooked up the Inovate LM1 to FS2 and error came up "controller not found". I used the mini 8-pin cable from the LM1 to a null modem adapter then the serial cable from FS2. The display on the LM1 is fine (14:7 AFR ) in closed loop. The display on FS2 shows locked on 1.7 Lambda, 25 AFR. Any idea whats wrong. This is with VPW- 99+ LS1 Auto (2004 Silverado)Thanks, Jim

[ChipsByAl]

Did you configure the FS2 options correctly(ie. choose wide band and Innovate)? It is also necessary to hit OK when done, do not back out.
Al

[02Z06]

Did you configure the FS2 options correctly(ie. choose wide band and Innovate)? It is also necessary to hit OK when done, do not back out.
Al
Settings are as follows: com in- Wide-02, com out- Wide-02, W02 Type- Innovate. Is this communication problem because of the difference between LC1 and LM1? Also with the LM1 I was just displaying the data, I wonder if you need to start "record" in order to have the data active thru the serial cable to FS2?