PDA

View Full Version : FlashScan to LC-1 Serial Cable Diagram



Blacky
May 20th, 2008, 05:04 PM
Diagram showing the various cables and pin-outs required to connect FlashScan to an Innovate LC-1 or LM-1 Wide band controller.

For those that want a simple cable solution, you can wire up an RJ12 plug directly to the 3 pin jack as follows:


RJ12 Jack
------ ------
1 <---> 1 (tip)
2 <---> 2 (middle)
5 <---> 3 (base)Regards
Paul

Blacky
May 20th, 2008, 05:29 PM
The null modem connector can be purchased here:
http://www.sfcable.com/cable/p/30D1-C1-S.html

If you want to make your own male-male null modem cable, see images below.
(Ok, so the soldering could be better, I'm just a programmer. Beware the programmer wielding a soldering iron...)

Regards
Paul

Blacky
May 20th, 2008, 05:32 PM
For those of you that can't locate your LC-1, LM-1 and/or FlashScan serial cables, this is what they look like.

Regards
Paul

joecar
October 15th, 2008, 11:56 AM
The names of the pins are as shown in the 3rd column:





RJ12 Jack Name
------ ------------ -----------
1 <---> 1 (tip) Tx Data
2 <---> 2 (middle) Rx Data
5 <---> 3 (base) Ground

joecar
October 15th, 2008, 12:07 PM
Innovate LC-1 and LM-1.

joecar
November 26th, 2009, 06:50 AM
Also see here: showthread.php?t=9340 (http://forum.efilive.com/showthread.php?t=9340)