FlashScan to LC-1 Serial Cable Diagram

[Blacky]

Diagram showing the various cables and pin-outs required to connect FlashScan to an Innovate LC-1 or LM-1 Wide band controller.

For those that want a simple cable solution, you can wire up an RJ12 plug directly to the 3 pin jack as follows:


RJ12 Jack
------ ------
1 <---> 1 (tip)
2 <---> 2 (middle)
5 <---> 3 (base)Regards
Paul

[Blacky]

The null modem connector can be purchased here:
http://www.sfcable.com/cable/p/30D1-C1-S.html

If you want to make your own male-male null modem cable, see images below.
(Ok, so the soldering could be better, I'm just a programmer. Beware the programmer wielding a soldering iron...)

Regards
Paul

[Blacky]

For those of you that can't locate your LC-1, LM-1 and/or FlashScan serial cables, this is what they look like.

Regards
Paul

[joecar]

The names of the pins are as shown in the 3rd column:





RJ12 Jack Name
------ ------------ -----------
1 <---> 1 (tip) Tx Data
2 <---> 2 (middle) Rx Data
5 <---> 3 (base) Ground

[joecar]

Innovate LC-1 and LM-1.

[joecar]

Also see here: showthread.php?t=9340 (http://forum.efilive.com/showthread.php?t=9340)