B0101 - Same whether using MAF or SD?

[LS1_Dragster]

I bet you guys are getting sick of the questions but I need to learn!

Would that table be the same whether your using the MAF or if just using Speed Density MAP? Is this a constant?

[joecar]

Above B0120: B5001 (MAF) is used.

Below B0120: if transient conditions, B0101 (VE) is used, otherwise B5001 (MAF) is used.

[LS1_Dragster]

This would be speed density mode that I'm programming in. So, without the MAF would that table be the same in both modes?

One would be able to bounce between using a MAF and speed density and not change that table correct?

[joecar]

Yes, in SD the airmass is calculated from B0101.

Yes, once you've got B0101 "corrected" (in OL, with MAF failed, see the Auto VE tutorial), then you set B0120 to zero and (still in OL, with MAF enabled) correct B5001 in a similar manner... then you can switch between SD and MAF without having to touch either table.

[LS1_Dragster]

Great thanks!