View Full Version : No Flash!
horsehaulin
May 31st, 2008, 04:30 AM
The ECM is locked up some how and wont let me load in a new tune. Now it has corruted the tune that was in it to the point that it wont let me start the truck! What can I do to get this fixed so I can get the truck back running to take my kids home tomorrow?
Tony
horsehaulin
May 31st, 2008, 04:32 AM
13:31:41.059: Checksum of flash failed after write completed. Please reflash the controller.
13:31:41.062: ECM is in an unknown state
This is what is being kicked back at me, I have tried slow speed and alt keys to no avail. I am in need of big help!
Tony
horsehaulin
May 31st, 2008, 07:08 AM
here is what I am getting when I try to send a calibration.
16:06:17.042: Reflashing ECM's memory...
16:07:11.281: Error: Failed. Controller has returned to normal operation, please retry the operation.
16:07:11.284: Reflash failed, aborting...
16:07:11.287: Total time: 00:54
16:07:11.289: Data compression achieved: 0.0%
16:07:11.470: Checksum of flash failed after write completed. Please reflash the controller.
16:07:11.474: ECM is in an unknown state.
16:07:13.583: Clear emisison related DTCs...
16:07:14.619: Current protocol set to: "SAE J1850 VPW"
16:07:14.651: Interface firmware version: 1.2.17
16:07:15.185: Clear DTCs for all modules...
16:07:16.001: Disconnecting ...
16:07:16.011: Disconnected
16:07:16.015: Reflash failed.
16:07:18.032: Done!
What in the world is going on?
Tony
horsehaulin
May 31st, 2008, 07:20 AM
Problem fixed! Mods, you can delete this thread. Thanks
Tony
horsehaulin
May 31st, 2008, 07:30 AM
Big weight off my shoulders!
Tony
2500HeavyDuty
May 31st, 2008, 10:21 AM
im having the same problem with a tune i got that im trying to load, but i just returned back to stock and truck runs.
But i want to get that tune workin though. any help?
joecar
May 31st, 2008, 01:25 PM
Tony, what did you do to fix it...?
2500HeavyDuty
May 31st, 2008, 02:24 PM
i just noticed my OS # was 15063376
and my calibration # was 15063375
dont they have to be the same?
2500HeavyDuty
May 31st, 2008, 02:25 PM
hmm, maybe not. must keep on looking
horsehaulin
May 31st, 2008, 03:17 PM
I just forced it by continueing to be more persistant than the ECM! So far it works perfect and loads up any calibration I am thowing at it now!
I ended up loading the same tune that was in it from the beginning and then recalibrating it to the tune that I wanted in it. I was running a big tune in my truck, and wanted to drop about 50- 90HP. It just stopped in the middle and wouldnt reflash. Dont know what happened, but it is now good to go.
Tony
2500HeavyDuty
May 31st, 2008, 03:22 PM
i tried another tune and it worked fine, something was just messed up with the first one i got.
thanks
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.