PDA

View Full Version : LM1 & Dynojet


minytrker
June 1st, 2008, 05:20 AM
Anyone use a LM1 hooked to there dyno? I just bought a new 224 dyno and wanted to use one of my LM1's for the WB on it. Any pointers on a clean install?
minytrker
June 5th, 2008, 01:22 PM
No one here owns a dynojet dyno and uses a LM1?
Gordon0652
June 8th, 2008, 03:40 AM
Dynojet makes there own AFR equipment and it doesnt have a 0-5v out put. I also just bought the Dynojet 224xLC and i bought the AFR computer.
I think you can not hook up an LM1 with a Dynojet...
Gordon0652
June 9th, 2008, 08:39 AM
I think you can not hook up an LM1 with a Dynojet...

I called DynoJet and you Can't hook them up.:bad:
minytrker
June 10th, 2008, 02:36 PM
They told me I could when I bought my dyno last month. They told me that I had to buy the analog module, so I bought that with the dyno and have it hooked up. The problem is I dont have the stting right for the voltage vs afr. I need to know the scaling for the lm1 as 1.0v - 5afr or whatever. With the analog module you can log alot of things if you scale them correctly in to the software for the dyno.
5.7ute
June 10th, 2008, 03:03 PM
Have a look in the LM1 programmer software. It will give you the voltage/AFR settings you will need. I have reprogrammed mine to the same as the LC-1 so I cant help.
minytrker
June 11th, 2008, 02:52 PM
Now, that I think about it, I think I have my LM1 programmed like a LC1. I have both and use the LC1 pid when tuning.

What are settings for voltage/AFR for LC1?
5.7ute
June 11th, 2008, 03:30 PM
0.879v at 10:1 AFR
4.215v at 20:1 AFR
Highlander
June 22nd, 2008, 04:22 PM
I am not really sure if using the LM1 is the best of choices given the A/D Conversion required to run it.

Now,
I have seen the LM1 connected on a dyno locally, so it can be done. Probably via the analog module as said.

The winpep software has provisions for the table and conversion to whatever you need it to be.

Anyways... I still think that the AFR module is the best bet.
bikeimports
January 26th, 2012, 02:56 PM
did anyone ever figure this out?
Gordon0652
January 26th, 2012, 02:58 PM
did anyone ever figure this out?

Yes. Sell the DynoJet and but a Land and Sea. Worked for me.
minytrker
January 26th, 2012, 09:35 PM
did anyone ever figure this out?

You will need to buy the $3,000 wide band from dynojet if you want a/f to be displayed on your dyno sheets. I sold my dynojet dyno and am switching to a mustang dyno most likely.