Help Repaired V2 now keypad issue

[modpcm]

Hi, I had a memory issue see this thread http://forum.efilive.com/showthread.php?t=8297
and send and received back my V2 , with Firmware 2.05.17 and Bootblock 2.05.08, Efilive explorer connect no problem , and upload from 1 ecm to my laptop no problem.

Now during the first 1-2 minutes the V2 is power on the keypads keys F3,up arrow,ok,down arrow don't work at all except if I press on one of those key with a lot of pressure ( I mean a lot ) then it start working then sometime pressing normally the arrow keys will make it jump 2 line at the time.

I try with V2 to pc only , V2 to car only , upgrade Firmware to 2.05.17 but no change.

Thanks
Modpcm

[Blacky]

Hi, I had a memory issue see this thread http://forum.efilive.com/showthread.php?t=8297
and send and received back my V2 , with Firmware 2.05.17 and Bootblock 2.05.08, Efilive explorer connect no problem , and upload from 1 ecm to my laptop no problem.

Now during the first 1-2 minutes the V2 is power on the keypads keys F3,up arrow,ok,down arrow don't work at all except if I press on one of those key with a lot of pressure ( I mean a lot ) then it start working then sometime pressing normally the arrow keys will make it jump 2 line at the time.

I try with V2 to pc only , V2 to car only , upgrade Firmware to 2.05.17 but no change.

Thanks
Modpcm

That can happen on some units due to a mis-configured Settings.dat file immediately after an upgrade. Run the EFILive_Explorer program, check in the [Config] tab page and delete the Settings.dat file. Then power off FlashScan, wait 10 seconds, power it up again - the keys should work normally again.

If that does not fix the problem, please contact Ira at Fish Tuning who did the warranty work.

Regards
Paul