LBZoom
July 3rd, 2008, 05:24 AM
Hey everyone,
I've got a 2006 LBZ with a stock transmission, I've got torque limits set by gear and RPM both on my tranny, and I've reset the TAPs after I flashed my ECM....from a dead stop when I mash it to the floor, my first gear runs up to about 3,000-3,100 RPM and hesitates before shifting into 2nd gear....is it slipping or perhaps performing a torque limiting function and cutting fuel? After it hits second, the truck just hauls ass! :rockon:
Also, when I'm cruising in 6th gear and I floor it, it takes a second for the transmission to decide what it wants to do, I don't think there's any slippage or anything, I believe it's performing a 6 to 5 to 4 shift, and because of this it's just taking a little longer, does this sound normal? :confused:
I've got a 2006 LBZ with a stock transmission, I've got torque limits set by gear and RPM both on my tranny, and I've reset the TAPs after I flashed my ECM....from a dead stop when I mash it to the floor, my first gear runs up to about 3,000-3,100 RPM and hesitates before shifting into 2nd gear....is it slipping or perhaps performing a torque limiting function and cutting fuel? After it hits second, the truck just hauls ass! :rockon:
Also, when I'm cruising in 6th gear and I floor it, it takes a second for the transmission to decide what it wants to do, I don't think there's any slippage or anything, I believe it's performing a 6 to 5 to 4 shift, and because of this it's just taking a little longer, does this sound normal? :confused: