EFI live won't see wideband...???

[rubbersidedown]

I have used this plenty of times before, and it quit working. My wideband reads propely on the display (innovate LM1) the output from the sensor reads 1-5 volts depending on driving (as measured @ the orange connector) I tell the software it is on A1 or A2 and it always shows that wideband is at 6:1 afr. any ideas???

[TAQuickness]

You could try:

Using a DVM to verify the analog signal your Flashscan unit is seeing
Double check the WB's analog out configuration (assuming the output is programmable)

[rubbersidedown]

i DID check it with a DVOM @ the orange connector @ the EFI live. It reads varying voltages (as with AFR changes) The scanner on the EFI live shows either 0 or 5 volts constant (one or the other, don't remember right now) ALL THE TIME, no matter what port i have it config'ed at or which one i have it plugged into. As i said, it had worked previously...

[TAQuickness]

Perhaps you should contact Ira for additional support.

[rubbersidedown]

who and how???
thanks

[joecar]

Ira (http://forum.efilive.com/member.php?u=416) (click on name) is an EFILive reseller and car/electronics guru located in Los Angeles.