BowlingSS
August 22nd, 2005, 11:24 AM
I am still getting a P0102 in my scanner. I do not get a light but P0102 is still reporting.
I disabled the MAF sensor by:
Set the Engine Diagnostics->Engine Diagnostics->MAF->Parameters:
• {C2901} MAF High Frequency Fail 1: 1Hz
• {C2902} MAF High Frequency Fail Limit: 1
• {C2907} MAF Test Min Engine Speed: 300 RPM
• {C2908} MAF Test Min Run Time: 0.1 seconds
Set the Engine Diagnostics->Engine DTC processing Enablers:
• P0101 ‘C’ Non Emissions
• P0102 ‘C’ Non Emissions
• P0103 ‘C’ Non Emissions
Set the Engine Diagnostics->Engine DTC MIL Enablers:
• P0101 ‘No MIL’
• P0102 ‘No MIL’
• P0103 ‘No MIL’
Set the Transmission Diagnostics->Transmission DTC Fault Max Pressure Enablers
• P0101 ‘No’
• P0102 ‘No’
• P0103 ‘No’
Is there another setting setting I need to change?
Bill
I disabled the MAF sensor by:
Set the Engine Diagnostics->Engine Diagnostics->MAF->Parameters:
• {C2901} MAF High Frequency Fail 1: 1Hz
• {C2902} MAF High Frequency Fail Limit: 1
• {C2907} MAF Test Min Engine Speed: 300 RPM
• {C2908} MAF Test Min Run Time: 0.1 seconds
Set the Engine Diagnostics->Engine DTC processing Enablers:
• P0101 ‘C’ Non Emissions
• P0102 ‘C’ Non Emissions
• P0103 ‘C’ Non Emissions
Set the Engine Diagnostics->Engine DTC MIL Enablers:
• P0101 ‘No MIL’
• P0102 ‘No MIL’
• P0103 ‘No MIL’
Set the Transmission Diagnostics->Transmission DTC Fault Max Pressure Enablers
• P0101 ‘No’
• P0102 ‘No’
• P0103 ‘No’
Is there another setting setting I need to change?
Bill