PDA

View Full Version : How do I make ONCLUTCH and OFFCLUTCH display in psi?


Sparky8370
August 3rd, 2008, 10:25 AM
Sorry, you don't get the easy response of configure display units. I can't log the on and off clutch pids in psi, only KPa. I remember reading here how to change the pid to read like I want it too but I can't find it.
Sparky8370
August 6th, 2008, 01:34 PM
OK where's that Joecar guy?
joecar
August 7th, 2008, 04:19 AM
lol... :hihi: ...I looked at it and it seems to have kPa units only... I'll pm tech support.
Blacky
August 7th, 2008, 09:28 AM
Its a typo in one of our config files. It will have kPa and psi in the next update which is due out tonight or tomorrow.

Regards
Paul
Sparky8370
August 7th, 2008, 01:16 PM
oh that's cool. Isn't there also a way to write your own? I'm not gonna bother now, but it would be good for future reference.
Blacky
August 7th, 2008, 04:24 PM
You could create a calculated PID that converts from kPa to PSI.
Its a lot of messing around, when it should be built into the software.

See this thread for instructions on creating calculated PIDs:
http://forum.efilive.com/showthread.php?t=130

Regards
Paul