6000 Stall - Logging PIDS

[boyley]

I am new to EFILive and am doing some logging this week for a guy with a 6000 no lockup stally. It hasnt been tuned to accept the stall yet. Which PIDs will be the best to log so the tuner can clearly see whats going on. Any tips appreciated.

Vehicle is 5.7L with MAFless tune.

Cheers Boyley

[OLS108]

6000 Stall ?? not markone2 is it :shock:

jks

[boyley]

6000 Stall ?? not markone2 is it :shock:

jks


LOL, I believe it belonged to a close native of the same state?

[brokenfly]

here is what i use from time to time,but i mostly just monitor input and output shaft speeds,along with pressure...


TIS..trans input shaft speed(watch engine rpms versus input shaft speed(flash) for overall difference)...
TOS...trans output shaft speed(when 1:1,look for slip from transmission,or factor in each gear ratio and do the math for slip in each gear)...
TFMPRS...trans pressure...
TRQTRANS or TRQENG...so it will show up in the tune tables...
TCCMODE...for apply and enable modes,coast,etc...

http://img166.imageshack.us/img166/73/transtunepidscv5.jpg

[boyley]

Thanks very much brokenfly