View Full Version : EFiLive and the '07 BCM
harascho
August 22nd, 2008, 04:44 AM
Hi... I ran into an interesting problem.
When I got my E38 ECU ,T42 TCM and the BCM together on a bench harness I realized that I was not able to see the BCM on the CAN bus. Are there any tricks to read and modify a BCM with EFI live?
Harald
Tordne
August 22nd, 2008, 05:59 AM
EFILive will not communicate with the BCM controller, only the ECM and TCM.
timunderwood
February 14th, 2011, 05:38 AM
are there any plans for efilive to start supporting bcm communication
Tordne
February 14th, 2011, 05:47 AM
Not at this stage sorry.
zrx1200
March 11th, 2011, 11:43 AM
would be nice to be able to clear codes (air bag)
joecar
March 11th, 2011, 12:47 PM
The EFILive V7 scantool can already clear codes on all modules on the bus...
go Edit->Properties->Advanced and checkmark Check/Clear DTCs for All Modules, click Ok;
then go Info->Clear DTC's for All Listed Modules.
zrx1200
March 12th, 2011, 10:12 PM
the omly module that is listed is the pcm not the bcm.thats usng v1 havent tried v2 on the ls1 yet
ScarabEpic22
March 13th, 2011, 10:27 AM
the omly module that is listed is the pcm not the bcm.thats usng v1 havent tried v2 on the ls1 yet
EFILive can still broadcast the clear DTCs message over the bus to all modules (so I understand), but it cannot do anything else to them.
joecar
March 13th, 2011, 11:24 AM
Also note: on 1998-2002 F-car the BCM is not on the serial bus.
zrx1200
March 13th, 2011, 09:54 PM
2001 commodore
Tordne
March 13th, 2011, 09:59 PM
Y-Body (Holden) will be the same. I think it will be on the ALDL bus.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.