PDA

View Full Version : LBZ 7.5.4 (build 66) Scan Failure with BBL Beta FW 2.05.20



Donovan
September 1st, 2008, 02:31 PM
Not sure whats up but I just updated to the latest BBL Firmware and the latest FS and I can't seem to be able to record or monitor realtime on my LBZ. I can however read DTCs and also use the LBZ bi-di's. I tried booting the flashscan hardware along with cycling the key on the vehicle. I also restarted the Scan software tool. Thoughts?

Donovan
September 2nd, 2008, 06:44 AM
I haven't tried this yet (trucks at the dealer getting new injectors), but perhaps not setting this cable type was the problem.

http://forum.efilive.com/showthread.php?t=6982

Donovan
September 11th, 2008, 01:43 PM
After playing with it some more, Here's some info on the repro:

When I dont select the BALRCYL1 through 8 it works perfectly fine. Also if i start it up and then add the balance rate PIDs it will display the balance rate at -395 for each PID however when i save that pid list and try to monitor it again it will error out and fail. I am wondering if this is an EFI Live problem or a controller problem. All other PIDs seem to be working fine.....

Paul/Ross, Any ideas on this one?