Dumb question...

[8100 Power]

Dumb question.

I got a SD card today to start BBL. But, I'm stumped as far as how to change the pids you can montior on the Flashscan. It gives me a list to select, how do you edit it?

Sorry for the stupid question. This is all new to me.

[bballer182]

you have to manually type them in the options.ini file you load on the FS unit.

[joecar]

You have to edit the file Options.ini located in C:\Program Files\EFILive\V8.1/Config...

Then connect your V2 to your PC and run EFILive Explorer (EE), click on the Config tab, drag the correct .pmm file (for your ECM) from the upper pane (your hard disk) down to the lower pane Config tab (your V2).

See these 2 sections of the readme file (see attached):


Configure FlashScan and/or AutoCal for BB logging
Using BB Logging




V2 BBL only works if you have updated your V2 bootblock, or if it already came updated.