Flashscan Won't LOG ANYTHING valid PID's too????? Help

[MN C5]

Installing the updated Version of EFILive corrected the problem. Thanks For All the Help


VIN # 2GTEK638071697432

OS # 12614088

Calibration # 12614085

Calibration Definition File (*.cal)

Name 12614088.calz

Version 7.21

So I got my supercharger on and want to tune it only to find I can flash and read tunes but Flashscan won't read or log any data.


It connects and validates the PIDS but doesn't display data or log it. Upon this first happening I was using a older build (#62 or something close). So I've now upgraded to build #66 and still Flashscan isn't working. Does it have some thing to do with the cal files... Help it feels dangerous driving without being able to see knock ect..


Thanks

Dennis

[joecar]

Dennis,

Did you select pids...?

Post some pics of your various tabs.

[MN C5]

I think so.... I've attached a excel spreadsheet with 4 screen shots. PID's, Data, Console & Dashboard.

Any help would be appreciated.:cucumber:


Thanks

Dennis

[MN C5]

I reflashed my OS from a Chevy PU to a GMC Denali on my ECM and didn't reflash the TCM. The TCM has a different reported VIN than the ECM. Could that be the problem?

Fudge...

[MN C5]

Anyone ? ? ? ? :help2:

[joecar]

On the Console tab, it says "Interface not detected"...

Check your connections...

Try Fast Stream mode (edit: I see it already is).

I pm'd tech support.

[MN C5]

TTT...:shock:

[joecar]

I bumped TS... Paul will get back to you.

[joecar]

Did you press the red record button...?

[MN C5]

Yes, tried both the red and yellow buttons. Same thing with both, nada...

[joecar]

Summary so far:
- Build 66,
- Connects and validates pids,
- Pids selected on PIDs tab, show up on Data tab,
- Does not log pids.

Did you enter a VIN/OS id to match what was flashed in...?
Did you select the controller to match the PCM/ECM...?

[Blacky]

After you try to start logging PIDs and you get the "Interface not detected" message, please manually generate an error report by selecting File->Generate error report. Then save and email the report to me at [email protected]. Add a link to this thread so I know what it is about, thanks.

Paul