Tuning tool not following scan tool (VE table)

[dvx]

I am tuning my 99 LS1 camaro, upgraded to 2002 os, then COS 3, with EFI Live version 7.5. I recently upgraded to COS 3 so I can run OLSD and keep my fueling in line using table A0014. I was scanning this morning and noticed that my VE table is not following the scan tool with respect to manifold pressure. When the scan tool reports 95 kPa, the VE table is in the 30 kPa column. The scan tool is set to report kPa, and the tuning tool is also displaying in kPa. It's probably something simple, but how do I correct this?

http://picsorban.com/upload/scan1.thumb.jpg (http://picsorban.com/upload/scan1.jpg)

http://picsorban.com/upload/ve table1.thumb.jpg (http://picsorban.com/upload/ve table1.jpg)

Thanks for any help - Dave

[dvx]

I found it.... NM.

:)

[joecar]

MAP units, right...? :D

[dvx]

Yep, in the scanner. Didn't realize I had to set the PID to metric. Dunno why I never ran into it before.