No A/F!!

[minytrker]

I have done the updates, (seemed to all go OK) But now I cant log my air fuel through serial. All I get is controller not found.

Need help ASAP!! Have car sitting on dyno since Friday with still no fix.
I have
bootware 2.06.02
16oct08

firmware 2.06.05
28oct08
__________________

[mr.prick]

you need to select the WBO2 through the V2.
F4 > F1 > F1 scroll down to WO2 type and select your WBO2 press Ok.

[minytrker]

you need to select the WBO2 through the V2.
F4 > F1 > F1 scroll down to WO2 type and select your WBO2 press Ok.


Thats all been done. It still says no controller found. It did work until the latest update.

[joecar]

What WB...?

[minytrker]

innovate lm1

[joecar]

Lorenz,

Did you set all of these:
- serial pids = yes,
- com in = wide 02,
- com out = wide 02,
- wo2 type = innovate,
- wo2 fmt = both,
- wo2 data = AFR & EQ.

[minytrker]

Lorenz,

Did you set all of these:
- serial pids = yes,
- com in = wide 02,
- com out = wide 02,
- wo2 type = innovate,
- wo2 fmt = both,
- wo2 data = AFR & EQ.



Yes,

I even tried changing them and then setting them back to what you have posted.

[joecar]

And you have the serial AFR cable plugged in...?

And this same cable worked before...?

[joecar]

I pm'd Paul... he may be on his way to SEMA which starts tomorrow.

[minytrker]

And you have the serial AFR cable plugged in...?

And this same cable worked before...?


Yes its plugged in. Yeah its worked for a good while, used it daily.

[mr.prick]

did you format and install all the config files?

[joecar]

did you format and install all the config files?Good point...

Reformat config tab, and redrag files down to config tab.

[minytrker]

Yes I tried that also. Is there any other config files for the wb somewhere else.

[joecar]

I pm'd tech support.

[Blacky]

There isn't anything else to configure (that hasn't already been said in this thread) that I can think of.

Unfortunately I don't have access to our development systems while I'm in Las Vegas so I can't check exactly what needs to be configured.

If you connect up the wide band and attempt to log wide band data (even though it may not actually log anything), then save a trace file on FlashScan and attach it to this thread I'll take a look.

Regards
Paul

[minytrker]

Its working now. I went through and re-installed everything again and it worked this time. I tried it before with no luck but it worked this time. Thanks for all the replies and help.