What are the exact steps for running an LC-1?

[nitrorocket]

I have it all hooked up and calibrated.

My question is... in my EFILIVE software, what do I activate and where do I find it. My EFILIVE instruction book is way to vague.

I have tried to use and can not get it to read on my EFILIVE. I have changed some settings, but it is not working.

Please help.

[Dirk Diggler]

The instruction manual was pretty straight forward for me

and this post was stickied right above your post. Easy to follow directions

http://www.efilive.com/forum/viewtopic.php?t=1145

Most of your questions have been answered at least 3 times on the board use the search feature and i am pretty sure it will steer you in the right direction..

[Blacky]

The LC-1 is now pre-configured in EFILive (V7.3) so you don't need to set up your own calculated PIDs.

Select and log the following PIDs:
{EXT.AD1} or {EXT.AD2}
{CALC.AFR_LC11} or {CALC.AFR_LC12}
{CALC.BEN_LC11} or {CALC.BEN_LC12}

Whether you choose "1" or "2" as the last digit in the above PIDs is determined by which pin you connected your LC-1 "Analog 2" wire to on FlashScan.
If you connected the LC-1 "Analaog 2" wire to FlashSCan pin "E", then use "1", if you connected the LC-1 "Analaog 2" wire to FlashSCan pin "C", then use "2".
Make sure you connect the Analog ground to PIN "D" on FlashScan.

Regards
Paul