View Full Version : 2007 LMM Speedo? HELP!!!
GAMEOVER
November 19th, 2008, 07:46 AM
I used the speedo calculator to adjust for bigger tires than normal everything worked perfectly: speedo matches GPS:) but ABS and E-Brake MIL showed up on dash and I can't figure it out...Did I miss something?
Nor-Cal Nick
November 19th, 2008, 08:36 AM
What size tires and what is the rev's you are changing it to?
GAMEOVER
November 19th, 2008, 09:57 AM
325-60-20 size...
GAMEOVER
November 19th, 2008, 09:59 AM
REV's ???
Nor-Cal Nick
November 19th, 2008, 11:07 AM
OK so I take it then you set it for 35's
rev's for your tire would be 592 per Nitto A/T and that = 35.12".
In the table (H0136) put 596 and you should be good.
The GM trucks don't like to see anything larger than 35's but even 35's set the ABS will go off so I tend to set it just alittle smaller and 596 = 34.8"
Post what happens...:cheers:
GAMEOVER
November 19th, 2008, 02:41 PM
I sure will....Thanks for your help!!!
The Neens
November 19th, 2008, 05:55 PM
Did the ABS light come on after installing the larger tires, or after using EFI Live to correct the speedo?
GAMEOVER
November 20th, 2008, 01:59 AM
After using EFI Live to correct the speedo... It had the "EDGE PRODUCTS" hooked up to it, I disconnected it, I corrected the speedo with EFI Live and after about 20ft or so the ABS & E-Brake lights came on...
GAMEOVER
November 20th, 2008, 02:00 AM
I'm going to try what Nor-Cal Nick suggested though:)
GAMEOVER
November 20th, 2008, 02:17 AM
The REV's after correction show -570/mile- Tire height 35.35"
Stock -679/mile- Tire height 29.79"
c55asleep
November 20th, 2008, 05:51 PM
Good info
flyguy_17
November 21st, 2008, 10:43 AM
I used the speedo calculator to adjust for bigger tires than normal everything worked perfectly: speedo matches GPS:) but ABS and E-Brake MIL showed up on dash and I can't figure it out...Did I miss something?
Hey I had this exact same problem on my 07.5 LMM! I am running 37s. I just figured I did something wrong in the calibration so I reflashed to the program I had before and haven't had time to mess with it since.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.