3bar custom OS questions

[QUICKSILVER2002]

I'm about to install the custom OS and have a few questions. The tutorial has a section about running in semi open loop. It says to disable closed loop and LTFT and then it states:

Several other STFT values may require adjustment:
• {B4101} Closed Loop Idle Vehicle Speed
• {B4102} Closed Loop Idle Vehicle Speed Hyst
• {B4103} Closed Loop Idle Throttle Position
• {B4104} Closed Loop Idle Throttle Position Hyst
• {B4108} STFT Idle Enable

In what way should these be adjusted? Would I want them similar to stock (enabled) or disabled.


[/quote]

[Tordne]

Check out http://www.efilive.com/forum/viewtopic.php?t=2037&postdays=0&postorder=asc&start=15.

I understand that you want it disabled. I asked the same question (below), and Ross confirmed. Doesn't get any better than that.
----------
I think you may need to actually set the values to the min. Reading the descriptions it says that the speed must be below the value for closed-loop fuelling to occur. This is assuming you wanted to disable closed-loop fuelling?

Is this right Ross?

I set {B4101}, {B4102}, {B4103}, {B4104} to 0 & {B4108} to Disabled. Is that correct?
----------

Cheers,

[bK]

Check out http://www.efilive.com/forum/viewtopic.php?t=2037&postdays=0&postorder=asc&start=15.


I think that has moved here. http://forum.efilive.com/showthread.php?t=832