PDA

View Full Version : selecting pids on v2



Aint Skeered
December 7th, 2008, 04:01 PM
I recently did the updates and now I can not see my a/f pid on my v2. I was at the track this weekend and hooked up my lm1 serial to my v2 and did not get any recordings of my air fuel ratio because of this..

How do we select what pids we want to see on hour v2 while bbl mode?

I was having to use the pid list that was selected by efi live and why would it start out with the air fuel and then in the updates take it away?

joecar
December 7th, 2008, 05:07 PM
On the V2 keypad/LCD, goto Options, Setup, Edit Settings, and then do this:

- set Ser Pids to YES,
- set Com In to Wide-O2,
- set WO2 Type to Innovate,
- set WO2 Data to AFR & EQ,

Press OK when finished setting those.

Those settings will cause the WB AFR/BEN pids to show up during V2 logging.

They were removed from Options.ini because they now show up if enabled.

Aint Skeered
December 8th, 2008, 01:45 AM
Thanks Joe. I have it done in my v2 now , I will hook it to my car and try it in a little while.

Aint Skeered
December 9th, 2008, 03:44 AM
Ok I tested it on my car and worked flawlessly. THanks again Joe.