PDA

View Full Version : Problems with Line Pressure


goldbergv95
January 3rd, 2009, 09:37 AM
Hey, Im about to get FLT IV trans mission installed and the problem is I dont know where and how to change the line pressure to stock. Can someone show me where to go in order to change the line pressure?
goldbergv95
January 4th, 2009, 05:39 AM
anybody??
ChipsByAl
January 4th, 2009, 06:22 AM
First you need to have a stock file to compare with. If you do not have an original file from your PCM before any modifications, check HoldenCrazy.com for one. Load your current file and then use the stocker to compare with. Note any changes in the transmission area of the program. Shift points by RPM and/or vehicle speed do not matter. Anything that has pressure or shift TIME will need to be matched to the stock file.
Al
goldbergv95
January 4th, 2009, 06:29 AM
So just to make sure, under category transmission, there is General, Shift at Speed, RPM, TPS, TCC, Trans Pressure, Desired Shift Times and Torque reduction.

The ones that I need stock is Trans Pressure and Desired Shift Time is that right just to make sure so that I wont break my new trans?
goldbergv95
January 4th, 2009, 09:01 AM
So just to make sure, under category transmission, there is General, Shift at Speed, RPM, TPS, TCC, Trans Pressure, Desired Shift Times and Torque reduction.

The ones that I need stock is Trans Pressure and Desired Shift Time is that right just to make sure so that I wont break my new trans?


?????
ChipsByAl
January 4th, 2009, 09:17 AM
Do a compare and see what is actually different. There might not be too much. If you are unsure, post both files.
Al
goldbergv95
January 4th, 2009, 09:18 AM
which one is what im asking.
joecar
January 4th, 2009, 09:33 AM
Post your tune file and the stock tune file.
goldbergv95
January 4th, 2009, 09:56 AM
herer is the tune
4508

here is the stock
4507
ChipsByAl
January 4th, 2009, 10:32 AM
The only tables that are pressure related and modified are D1108 and D1109 for the 4.10 TM Stock Pressure.tun vs. 02 LL8 Stock PCM.tun. Is that your newest file or is it 3tune1_update1.tun?
You may want to check with FLT on their Torque Management requirements if any.
Al
goldbergv95
January 4th, 2009, 10:33 AM
they said that TM equalling to 0 is fine. Thanks for the help!
goldbergv95
January 4th, 2009, 10:39 AM
you know what check this again this time because the other tune i modified a little. Here is my stock and the exact tune up from pcmforless

4511

4512
ChipsByAl
January 4th, 2009, 11:24 AM
See tables D1108 and D1109, they are related to pressure.
Al
goldbergv95
January 4th, 2009, 11:26 AM
but what about the trans pressure?
joecar
January 5th, 2009, 05:41 AM
D0701-D0703 shift pressure tables... they already look stock.

I don't see any tables for mapping the PCS solenoid.