PDA

View Full Version : Alarms when logging from V2


MMLMM
January 18th, 2009, 01:01 PM
When I setup an alarm for instance ECT:

Does the value I put in have to be in *C or *F?

If I press enter on the V2 and view data in *F, will the alarm switch to read *F or still *C temps.
joecar
January 18th, 2009, 03:34 PM
It has to be in metric units °C...

pressing ENTER (to display imperial units °F) only changes the display... the alarm will still work correctly as it is based on metric units.
MMLMM
January 18th, 2009, 03:40 PM
It has to be in metric units °C...

pressing ENTER (to display imperial units °F) only changes the display... the alarm will still work correctly as it is based on metric units.

Thanks. I was in the middle of testing, but you responded before I finished, lol.


Heres another,

I selected to light 1st LED and sound mid tone, (i added the numbers together) but all I get is the tone, no light. I then tried another LED and a higher pitch, and it only toned for the time I setup, then wouldnt do it again until I reconnected?
joecar
January 18th, 2009, 03:47 PM
There is an option in the V2 setup options for LED Mode...

LED Mode is "status" by default, you have to set it to "alarm" (or something).
MMLMM
January 18th, 2009, 04:06 PM
There is an option in the V2 setup options for LED Mode...

LED Mode is "status" by default, you have to set it to "alarm" (or something).

Man your on Fire tonight, lol.


Thanks. :rockon: