Printable View
I'm working with a 2008 Trailblazer SS E67 and want to use ECM C3 pin 66 and C3 pin 67 for VSS high and VSS low because of a manual transmission application. While this looks good on paper, I'm not seeing a VSS signal in the scan tool.
Has anyone eliminated the T42 (which has a VSS output to ECM C3 66), used a manual transmission, and a VSS signal directly to the ECM?
This is not yet installed in a vehicle, but being tested on the bench.
I added the TCM to the bench and the VSS works fine. I'd like to avoid the TCM if at all possible.
Maybe using an 07 CTS-V calibration would be a better option?
I agree! The only catch is that the project requirements include cruise control...which locks me into the Trailblazer SS E67 ECM.Quote:
Originally Posted by GMPX
Do you have the parameters
- Vehicle Speed Output = RepTOS
- Wheel Speed Output = Enabled
- Speed Limiter Source = Calibration
The pins are the right ones
The first two parameters are what i needed to change to get the GMPP E67 controller to work along with writing the entire file versus just the cal several years ago
thanks
alan
Thanks Alan.
Are these EFILive parameters or HP Tuners. I cannot find these in the EFILive E67 ECM calibration.
*EDIT* I don't see these in HP Tuners either. Maybe this is specific to the GMPP calibration?
Quote:
Originally Posted by alan91z28
Those settings are used by default in a Trailblazer calibration ... no worries if you can't access them.
Regards,
Taz
Thanks Taz.
I can also tell you that without the TCM, SAE.VSS always displays 158 mph. I disabled U0101 (Lost Communication With TCM) with no effect on VSS.
yes you're are right Taz i just looked in a reference file for the trailblazer and those are indeed set that way
mike, i am not sure where these are in EFI Live, in HP they are under the speedo tab and they are set like i referenced on the trailblazer when i just looked
the other thing i noticed is that there are a couple of weird DTCs that might give you some trouble... try turning off p608 and see if that helps
what do you see the vss ppm out signal C1 39?
right now in my 85 IROC with the LS3 type and TVS2300 i am running the GMPP ECM
- GMPP E67 ECM Part Number 19258268 (pre-loaded with GMPP OS 12638778)
- GMPP OS 12638778 baseline
- heavily modified of course, but this is a great OS to start as great MAF range and Fuel (up to 16 g/s injectors)
i am not sure if they have made these OS available over their web interface yet... it would be great if you could just load up an e67 with it
What are you using to input a VSS into the ECM? Its going to read a funky value unless you feed it a proper signal, start with that and adjust the speedo params if necessary.
Ive looked into this a bit when one of the TBSS guys was trying to swap a T56 into his TBSS. He scrapped the project, but Im pretty sure you can run the stock OS and kill the related codes for the TCM.
Can you post the base file you're working with? And what kind of vehicle is this going in, sounds like a swap (just curious!).