Serial wideband not reading in scan V7.5 correctly

Hi all,

so before updating to the latest version of v7.5 and v8 and the firmware etc, my innovate MTX wideband connected fine to the flash scan and then read correctly in scan V7.5

Now I can get the Wb hooked up to the flashscan and reading correctly (matches the MTX gauge), but the serial wideband pid just reads solid at 10?


Is there an issue in V7.5 , d I have to migrate to scan in V8 now?

Found a potential solution in another section, could be due to the latest update being build 282 NOT 283, so need to run updates in V7.5.

Hopefully this solves the problem

Let me know how it goes...

Paul did fix a serial comms wideband problem.