Split BEN Maps for boosted AutoVE?

I am using separate BEN maps derived from A0009 and B0101 for AutoVE tuning. Is there a way to prevent everything from above 105 kPA from going into the 105 column in the lower map and everything below 105 kPA from going into the 105 column in the boost map. For now I have just created filters to clean them up.

I got odd behavior using split maps that had the 105 column duplicated and went to a single map. I don't find it difficult to copy the needed portions of the map.

I had been using a single map also. Thought I would give the split map method a try.

Did you guys start out with single MAP for AutoVE and Boost?

Just use 0-105 kPa to update B0101 and 105-XXX to update A0009?

Is that right?

Thanks
Lonnie

Quote:

---

Originally Posted by lplott

Did you guys start out with single MAP for AutoVE and Boost?

Just use 0-105 kPa to update B0101 and 105-XXX to update A0009?

Is that right?

Thanks
Lonnie

---

Yes. I don't think it matters if you select the entire map when copying and pasting, as long as you do it "with labels".

Don't know if the different scaling of the two tables affects anything though.