Greatly appreciate this and will give it a try.
Printable View
Greatly appreciate this and will give it a try.
I tried clicking on status and states, warning flashscan v2 not in dead poll mode
To put FlashSCan in dead-poll mode, hold down the [Ctrl] button on FlashScan's keypad while connecting the USB cable (i.e. while powering it up). You can tell it is in dead-poll mode when the two orange LED's flash alternately.Quote:
Originally Posted by 97power
Regards
Paul
Thank you so much Blacky. Everything worked great and was able to flash a computer. Again I appreciate you taking the time to explain it even though instructions are good I just realized when you walked me through it, everything started to click in my head. Great support!
My flashScan will not work either. It is showing firmware version 2.05.21 It is also showing Boot Block version 2.05.04 and its showing I need to upgrade to 2.07.07 but will not upgrade
I can only get it to show this if I hook it up in dead poll mode otherwise it will just show it is not connected or responding.
I also have no F4 under licensing to upgrade Boot-block.
You may need to follow the "recovery" options explained in the document:Quote:
Originally Posted by Tecks
\Program Files\EFILive\V8\Firmware\EFILiveRecovery\ReadMe.t xt
Regards
Paul
Thank you, I now have 2.07.64 for firmwire and 2.07.07 boot block and shows to be working
I guess there is no need to Register the V8 software? I just got a new laptop and I don't see anywhere in V8 to input Serial, Key, and Issued Date. My V7 is already registered.
That is correct. Registration won't be necessary until the V8 Tune Tool editor is released. And even then it may end up not being required.Quote:
Originally Posted by Boost
Regards
Paul