Printable View
OK I am trying to wire the valet mode toggle.
Here is where I am at...where do I go from here?
http://www.retrorelics.net/jim/Boards/EFILive/PCM1.JPG
http://www.retrorelics.net/jim/Boards/EFILive/PCM2.JPG
Where is this pin 56?
Looking at my PC Parts bin for the wire :cheers:
On the PCM harness, there should be numbers indicating pin 41. Start there and count to the left to 56. I'll post the pin outs, if I can find them, from the service manuals in a few minutes.
Here's the pin out of the red harness. The pin you want is inside the red do-nut.
Yeah then take the grey plastic cover off and push a new socketed pin through so it connects with pin 56 when you reconned the plug. Then replace the grey cover. All you need to do is put a 2 pole switch on for open and earthed, your job is then done.
Set your custom OS valet settings for max speed and rpm and all is well.
Hey can anyone tell me if setting max rpm to under idle speed the car gets killed? I keep forgetting to try it.
I'd say it would do, didn't test it though either. I set the RPM limit to 1500 and speed to 20km/h. Fair to say that it is fairly abrupt in first gear (M6) when the fuel cut happens :)
Thanks guys!
I will get on that tomorrow, I take it the other cover has the numbers 81-160 for pinouts? I took off the right cover?
Beer
Both the connectors have repetitive numbers. They are distinguished as being either the Blue or Red connector :)
Did you get the proper PCM connectors? I got mine from www.eficonnection.com, and they are perfect!!!
OK so looks like I guessed good and got the red one, I take it the other is blue in color (and I don't intend to mess with that at all).Quote:
Originally Posted by Tordne
What do I need for PCM connectors? I thought I just need to punch a hole and run a wire (using an PC LED wire) in the hole?
http://www.eficonnection.com/eficonnection/100w.aspx 18 gauge or 22-20 gauge?
I got 10 of each sent down here seeing as they cost basically nothing... I think I used 18 for the valet cause the wire was thicker than the FP harness wires.
Ordered both type connectors.
Waiting on the LT headers and connectors to procede with the project.
On to the console, have some dremeling to do to for the switches :cheers:
http://www.retrorelics.net/jim/Board...lfacejan07.JPG