I had the speedometer isssue after installing 7.51. Reducing the number of pids selected cured it.
Printable View
I had the speedometer isssue after installing 7.51. Reducing the number of pids selected cured it.
Good to know!Quote:
Originally Posted by jfpilla
I guess it did start with the later versions.
Seems to matter not what one sets the VVS values to, and the car speedo reads fine.
i have noticed the imperial settings on the PIDs tab
are still inHg and the tune tables are PSI for imperial settings.
this goes all the way back to when V7.4 was released.
i`m not sure if it will cause a problem when using BEN,
but it is a little annoying. http://smiliesftw.com/x/chaise.gif
Yes i noticed that the pid count would peg at 25 and it would stay there.Quote:
Originally Posted by jfpilla
I checked to see what mode I was logging at.Its when I reduced the number of pids below 24 it came right.
It shouldn't be like that.
Its good to know its not only happening to me.
I went back as I said to an earlier version and will wait for a stable release.
May be I'll retry in case its been fixed.
Thanks for clarifying.
Sometimes when I am working on a tune with tune and log open and I apply the filter or hide cell count buttons...the whole log vanishes.
I have to open it again and the filters etc have been applied.