Printable View
No, not in the latet Update 02. The Update 02 was not a scheduled update. It has been released to combat a VIN licensing error. The next scheduled update will address the other issues that hav ebeen raised with 7.4 so far.Quote:
Originally Posted by mr.prick
Regards
Paul
I have a problem to ,The MAP is in kPa and is running in inhg Even the screen is showing it in kPa but it runs in inhg,I have every thing set in metric, but the MAP is running in inhg in only in (EFI Live V7.4 Tune) but not in (EFI Live Scan) it works just fine, I hope i explained this right
Not sure I understand your current setup precisely, can you post up a screen shot?Quote:
Originally Posted by RandyWS6
Paul
also the scan wants me to select the pcm type each time i connect
even after i check the dont ask again box.
Attachment 1479
That was implemented in the 7.4 release. The check box disables further prompts for the life of the Scan Tool session. When you close and reopen the Scan Tool the question will be prompted again.Quote:
Originally Posted by mr.prick
And it was done for a good reason. We had too many support issues with customers setting it to say LS1, then switching it off. Then next session attempting to connect to some other type of controller and not realising that the software was attempting to connect to an Ls1 controller. So now the user must make the controller choice each time the software is started.
In the next major release (EFILive V8) we are be working on a more "user friendly" approach.
Regards
Paul
I need to take to some body on the phone ,just cant explain it on here.a screen shot ,i dont beleave it will explain it, it hast to be running to see it. can some one give me a number i can call ? PM me the number , Ive been trying to AutoVE but cant.
I've had other reports of the same issue. There may have been a units conversion fault during the calibration definition file build process. We are investigating and will post up a new software update if required.Quote:
Originally Posted by RandyWS6
Meanwhile, you shoul dbe able to continue AutoVE tuning if you set both the Scan Tool to kPa and the Tuning Tool to kPa.
In the Scan Tool, it doesn't matter what units the charts or dashboards are showing, what matters is the units that are showing in the [Data (F9)] tab page.
Regards
Paul
can i AutoVE my MAP's in (inHg) ? And copy and past after logging.
You can really use what ever units you like. The key is that the Scan Tool and Tune Tool must be using the same units for the values to be appropriate. Having said that the AutoVE process uses BEN factors. Given that the tables don't change dimensions you could still copy paste/multiply etc, just not using the "with labels" functions.Quote:
Originally Posted by RandyWS6