BB Logging update (March 4th)

Quote:

---

Originally Posted by Ninety8C5

The female 9 pin connector I have has pin 1 where you have the ground connected. From what I found on the web, the male and female pin designations are reversed. i just want to be sure which way to wire the db-9 plug.

---

It was a late night, my bad. The plugs are both MALE, not female. No wonder I had trouble dating when I was at school.:frown:

I'll post new images....

Regards
Paul

Quote:

---

Originally Posted by tunedbyGM

Does it matter which end connects to where , one end for LC-1 and other V2 ?

---

The crossover cable is symmetrical, it can be connected either way.
Regards
Paul

New (corrected) images are posted in the first page of this topic.
Regards
Paul

Quote:

---

Originally Posted by tunedbyGM

Oh God that is great , no more Analog inputs for the LC-1 ! :notacrook: :jump:
I have one of the JAW's , Just another Wide-band (not assembled yet) , with a Serial out on it as well , wonder if it will work ?

---

If you have the data format specification that it transmits, let me know and I'll add it as a supported device to FlashScan.

Regards
Paul

Paul, cool... good job mate... :cheers:

An alternative to fabricating a cross-over cable is to slice up the LC-1 serial cable, swap and solder 2 wires, and apply heat shrink tubing or tape... doing it this way is dirt cheap.

Quote:

---

Originally Posted by joecar

An alternative to fabricating a cross-over cable is to slice up the LC-1 serial cable, swap and solder 2 wires, and apply heat shrink tubing or tape... doing it this way is dirt cheap.

---

Post some pictures of the Mod !

Quote:

---

Originally Posted by joecar

An alternative to fabricating a cross-over cable is to slice up the LC-1 serial cable, swap and solder 2 wires, and apply heat shrink tubing or tape... doing it this way is dirt cheap.

---

But then you can't program or log the LC-1 from the PC.

Regards
Paul

It may be possible to just order this adapter:
http://www.bb-elec.com/product_family.asp?familyid=52 Product 9SGM.

I have just asked B&B if that adapter crosses over pins 2 and 3. I'll post up the reply when I get it.

If it does cross over pins 2 and 3 then you can use it, if not then back to fabricating your own.

Regards
Paul

Quote:

---

Originally Posted by Blacky

If you have the data format specification that it transmits, let me know and I'll add it as a supported device to FlashScan.

Regards
Paul

---

Will see if I can acquire .

Quote from JAW website :
"Only Pin 2,3 and 5 are used by JAW."
Further info when acquired .