Is it possible to log for CALC.CADEG in E38 ? (crank angle degrees injector open)
I added the pid but it's looking for GM MAINBPW which reports invalid ??
Printable View
Is it possible to log for CALC.CADEG in E38 ? (crank angle degrees injector open)
I added the pid but it's looking for GM MAINBPW which reports invalid ??
For E38, try using INJPWB1 and INJPWB2 instead.
You could also re-validate PIDs while connected to the E38 to make sure those two PIDs are supported.
Reagrds
Paul
CALC.CADEG and GM.MAINBPW are for the GM diesel controllers, not for the GM gasoline controllers.
BTW:
Paul mentioned GM.INJPWB1/2, these are the injector pulsewidth pids for E38 (and every non-LS1A non-LS1B gasoline controller)..
in the attached calc pids file, you will find injector duty cycle pids for based on GM.INJPWB1/2.
Thanks Paul and Joe,
I created a calcpid by copying the function from CADEG to RABCADEG and replaced GM.MAINBPW with GM.INJPWB1.
Seemed to validate ok and appears in the list of pids when monitoring live data with the V8.
However no actual data shows up. Admittedly I fumbled this far, thought I'd loaded the pid list to the v2 for bbx logging,
but it does not show up......so quite lost now.
I just want to datalog injector timing, is this possible with E38 ?
That calculation is not correct (it produces a very small number).
Ok can see some numbers now if I reduce the large divider number, but don't understand how that relates to injector timing ...
so back to my question, is it possible to datalog injector timing for a E38 os1264402 ?
That calculation is not for gasoline ECM's.
See this post above:
Gasoline ECM's provide pids for injector pulsewidth (from which the duty cycle can be calculated);
there is no pid (that I can figure out) for crank angle position related to injector timing for gasoline ECM's.