-
Bbx and pids
I have been reading how to load pids in to V2 and am getting confused, I have loaded the pids from the list in S&T and can log them OK, but some of the ones like injector duty cycle are not there. How do I add pids from V7? into V2 I am only talking about LS1B:cheers:
-
The LS1B injector pids are GM.IBPW1 and GM.IBPW2.
The pids CALC.INJDC1 and CALC.INJDC2 can be applied to the log afterwards.
Make sure V8 is at build 203 and V2 firmware is at 2.07.35, and that you do Program All (accessed via the down-arrow next to Program).
-
Thanks joecar that worked
-
Im trying to Log Grams/cylinder GM.DYNCYLAIR_DMA but cannot find it to put in V2 what should I be doing?
-
DYNCYLAIR_M is the PID in v8
-
+1 that is correct (the _DMA pids are suffixed to _M for BBL).
-
I dont seem to have that pid in S&T under LS1B
-
Do you have V8 build 203 installed...?
In the yellow section on the right, click on the column heading that is the pid name (this sorts alphabetically) and scroll down, you should see it.
-
yes build 203. I even searched with its name in the key words
-
http://i172.photobucket.com/albums/w...filive/DYN.jpg
Should be there. Don't think there's a requirement for other pids to be selected either.