-
Eops
Trying to log EOPS. Sent the PID to EFI, connect it to car, start logging and I can see EOPS varying like it should. Save file, shut down, connect to computer, and .... no EOPS?
Any ideas?
Using LS1B_A for a 2000 LS1 Corvette.
EFI V8.2.2.258
Firmware 2.07.64
Boot 2.07.07
Thanks!
-
-
1 Attachment(s)
I tried EFI 7.5 and it can see EOPS!
Am I doing something wrong with V8 or is another thing thats not quite ready?
Thanks
-
You have to select the pid CALC.EOPS and then save the log (no need to re-log).
-
So I go into V8. Select Scan. Open log file, and can't find CALC.EOPS under available PID's.
Actually, why would I need the calc pid (even though I can't find it)? I'm not trying to calculate the pressure, I can't even view the voltage (in V8).
I can view the voltage (EOPS) and calculate the pressure in V7.5.
-
No one ........
Guess I'll bounce it to the support side.
-
Sorry, my internet connection has been down for a couple of days...
Calc pids are added in later when viewing the log file.
So can you view EOPS pressure in the V7 scantool...?
So in V8 and V2 BBL you can't see the EOPS voltage pid, is this the crux of the issue...?
-
Log file was acquired via BBX.
EOPS Voltage can be seen on the V2 while BBX recording.
EOPS Voltage displays fine in V7.
Can't see EOPS voltage pid in V8.
-
Ok, I pm'd Paul, he said he's looking at it.
-