V2 Licensing Questions

Hi all,
if I reorder from the store, I notice it retains the old Authorisation code from the previous purchase. I normally change this the new code, but do I have to do that? I don;t want to forget and screw up a purchase.

Also, if I purchase a stream license (E38 or LS1B), am I still limited to 220 VIN's in the V2 in total?

Thanks in advance :)

You should generate a new auth code each time you order.
Once you have a stream licence then any subsequent ECMs that use the stream license do not use a VIN slot and are not counted in the 221 limit.
Regards
Paul

Awesome! Thanks Paul. efiLive has awesome support and response times :)

Especially when Paul is 'supposed' to be on holidays at the moment :shock:

:exactly:

What should i do when i reach the limit of 220 Licenses ?
I'm @215 now !!

Buy another V2 and load it up with streams !!!!

Either purchase streams for the supported controllers or purchase another V2.

Quote:

---

Originally Posted by wesam

What should i do when i reach the limit of 220 Licenses ?
I'm @215 now !!

---

There is a discount when purchasing a replacement FlashScan if/when you run out of VIN slots. Contact sales@efilive.com for more info on the discount and how to obtain it. If/when you do order a replacement make sure you specify your current V2 license number. The replacement V2 will be set up with the same license number before it is shipped to you.

Regards
Paul

As a efilive newbe and getting ready to buy a GM V2, will I be able to pull in a base config/tune and use it to learn the software without burning one of the VIN as long as I don't write it back to the ECM? I just want to learn where everything is on the screens/pages. I have done some tuning in the past with other software but not the efilive.

Regards Don...

1952 Dodge Pilot House Gen III V8
1949 Chevy Panel Van Gen III V8

Quote:

---

Originally Posted by dbertram

As a efilive newbe and getting ready to buy a GM V2, will I be able to pull in a base config/tune and use it to learn the software without burning one of the VIN as long as I don't write it back to the ECM? I just want to learn where everything is on the screens/pages. I have done some tuning in the past with other software but not the efilive.

Regards Don...

1952 Dodge Pilot House Gen III V8
1949 Chevy Panel Van Gen III V8

---

Yes, without using any VIN licenses you can read and data log whichever (and as many) controllers that are supported by the FlashScan version that you purchase (i.e. GM, Cummins or GM&Cummins).
You only need to use a VIN license when you flash a controller.

Regards
Paul