-
E37 Bench harness Pins
Searched on the help- bench harness tutorial info, and didnt find the info for the E37, wich are the pins needed on a bench harness for the E37..
im using 19-switched ignition, 20-battery, 73-switched ignition, 43 and 44 CAN signal on C1, on C2 73-ground, is this correct?? cant read a E37 ECM, maybe the ecm is bad. just want to check
-
1 Attachment(s)
There are probably many ways to build a Bench Programming Harness for the E37. The PDF attached below is just one possible way to do it.
I would use only the C1 / X1 / J1 connector (call it what you will) - similar to an E38 setup.
-
-
-
hi is possible y send me the e37 pinout , or the ecm shematic.
thanks
-
I've tried this one and others on 3 different ECMs and can't connect to any of them. Any ideas?