V2 stuck in reboot after 2.05.10 FW
Hello Paul,
first everything went fine, updated to the 2.05.10 firmware without issue.
Then I watched some logs I did with the old 2.05.09 FW, saw that
no maf pid was shown from the 97/98 controller and added a line for maf and commanded afr to the config.ini. Copied this to the V2, disconnected and went to the car for logging.
Now the unit is not booting correctly and stucks on the splash screen.
It cannot be found by efilive explorer (device is not connected) until it is in dead poll mode (no problem to enter). The 2.05.10 fw can refashed without any issues. But downgrading to the older versions is not possible and causes an $008e error code.
After the splash screen is visible the right green led is flashing 5 times and the message appears that flashing was successful. Then the V2 is stuck:bawl:
Could this caused only by editing the config.ini?
What can be done?
Many thanks in advance!
Marco