I got to the controller, and the "activate" I don't see a learning sub tab where I can click "CASE"
E38 2007 corvette
Idling in drive way now.
Elmer
Printable View
I got to the controller, and the "activate" I don't see a learning sub tab where I can click "CASE"
E38 2007 corvette
Idling in drive way now.
Elmer
I see
exhaust cam phase solenoid bank 1
exhaust cam phase solenoid bank 2
intake cam phase solenoid bank 1
intake cam phase solenoid bank 2
Right colimn
4 blocks for degrees with all of them showing 0 degrees
You mean an option next to the CASE like in the others you mention correct. Not just the CASE under the ECM Setup.
Brian
Well while sitting here, I went into the ECM setup tab and found C.A.S.E.
Is that what you guys were referring to?
DVT - ECM Setup - Activate - CASE - 4000 roms - stumble, idle down - turn off engine - click deactivate
With possibly having my foot on the brake?
Yes that is where I found it. So I can do the relearn with the above instructions?
Ok good you have it figured out.
Brian
Did it twice. Did not fix my issue.
Thanks for responding
Elmer
What's the problem ?
http://forums.corvetteforum.com/c6-f...h-e-force.html Long and challenging. Best improvement so far was new 65 FAST injectors. I'm having high boost and KR now that I'm running the new replacement SC. We're looking to check the CATs to see if I'm plugged. I have a larger SC pulley in hand to pull back on the boost of the CATs are clear. I'm putting on LG hEaders this week too. Sigh...
Elmer
Here too but this refers back to the same big thread on the corvette forum http://forum.efilive.com/showthread....ing&highlight=