-
Dsp5 not switching tunes
my dsp5 is not switching tunes i checked can rechecked to make sure that the wires where in the right holes. I have taken a meter to them and got resistance and the resistance would chang when swithing the switch. On my lap top i have tryed to log data from the dsp voltage and it wont log anything saying that one that one pid has been selected and i checked to see if anything else was selected and nothing was and it also said to change the scanning speed. Only one of the tunes was able to be loaded to the truck.. Anyone got any ideas why the other tunes are not loading or what could be wrong
-
Dsp5 not switching tunes
Did you do a full flash, or a cali flash?
-
-
can you data log either dsp5 voltage ( lb7-lly or lbz) and dsp5 tune#
also check in you tune where the volages are set for each tune. i got caught with this they were all set at 0 voltage
-
when i try to log data it says more than one pid has been selected when i have only clicked on one and then tryed to change the settings that it says to have on the pop up error and retry it and it just says the same thing
-
-
Where did you get your switch? What kind of vehicle are you attempting to flash?
Cheers
Cindy
-
I got the switch from diesel addiction and it's for a 2005 duramax lly
-
Time to post a screen shot.
Cheers
Cindy